I've had this NOE 45 cal. mold for a couple of years it will cast flat nose, cup point or hollow point bullets. I've mostly been casting the HP bullets and the occasional cup point but I like the HP's much better.
I cast my HP bullets from 50/50 alloy, let them air cool after coating and size to .452" they drop from the mold at around 220 grs. and I shoot them out of my Hi Point 45 carbine and Ruger P90 an get excellent accuracy with both. Here are three examples I coated with Eastwood Silver Vein, Smokes Transparent Copper and OD Green from a local powder coater. I push these bullets with around 6.9 grs. of Power Pistol and get close to 1100 fps. out of the carbine.
Recovered bullet for a previous expansion test I did in wet pack media which is not the same as ballistic gel but if done properly is pretty close. https://www.frfrogspad.com/wetpak.htm
I have my carbines red dot set up for the Lee 200 gr. SWC. The NOE 220 gr. HP shoots about an inch lower with the current setting so I just had to make a quick visual adjustment to my POA and shot the last five shots, they stacked up pretty nicely.
Very well done